$79.80
A 20″ notched blade built for the Kwik-Till HSD Series, mounting on its own 4-bolt hub instead of sliding onto a shared gang shaft. The notched edge is cut for higher working speed and heavy residue, not for flute-based soil fracturing. Ingersoll-manufactured. Cross-references to Norwood #90-34-0002 and John Deere #5NS90340002. 6.5mm gauge.
This one isn’t a flute-count blade like our Soil Razor or Wave lines — it’s a notched design, built specifically for the Kwik-Till HSD Series. The notches along the edge are cut to run at higher working speed and cut through heavy crop residue instead of pushing it down into the ground the way a smooth or lightly-worn edge tends to once residue builds up.
Mounting is different too. Most of our blades slide onto a shared shaft as part of a gang, secured by two end nuts. This one bolts to its own individual hub on a 4-bolt pattern — closer to a wheel hub than a gang-mounted blade — so it comes off and goes back on one blade at a time.
We distribute this one rather than cutting it to a Real Harrows spec — it’s a standard Ingersoll part, and Ingersoll’s machining and edge finish are about as good as this category gets. If you’re searching by dealer part number, it cross-references to Norwood #90-34-0002 and John Deere #5NS90340002.
Because this blade mounts on its own hub instead of a shared gang shaft, you can pull and replace a single blade without disturbing the rest of the row — no need to break down a full gang for one damaged blade.
In stock and ships fast from our Wisconsin warehouse — less time waiting on parts, more time in the field.
Not sure this is the right blade for your machine? Call us at (920) 464-0779 — we’ll help you get the correct fit before you order.
A notched blade isn’t measured by flute count. The notches along the edge are cut for high-speed residue cutting, not for moving or fracturing soil the way a fluted blade’s flutes do. It’s built to run fast through heavy residue instead of hair-pinning it under the blade.
No — this one bolts to its own 4-bolt hub, like a wheel hub, instead of sliding onto a shared gang shaft. You can pull and replace this blade on its own without taking the rest of the gang apart.
It’s a standard Ingersoll part — we distribute it as-is rather than cutting it to our own spec. Ingersoll’s edge machining and finish are about as good as this category gets.
Norwood #90-34-0002 and John Deere #5NS90340002.
Call us at (920) 464-0779 or reach out through our Contact Us page — we’ll help confirm fitment before you order.
| Weight | 22 lbs |
|---|---|
| Dimensions | 20 × 20 × 1 in |
